Mikrotik wan failover reddit. Current solution isn't optimal as it takes a lot of time to failover and is rather fast to get back before primary link is stable enough. 1 day ago ยท Hello I am using 2 WAN on a mikrotik (ether1 and ether2) and i have 2 subnets (native 192. Is it possible to set up a dual WAN failover that ties into their existing infrastructure? They don't use Mikrotik products and I don't want to touch their existing infrastructure. 10. I have added a fiber handoff into the 5009 with a public IP off of this connection. I use recursive routing and tried to achive that with mangle rules . However, I've reached edge case - ISP's gateway is working fine, but still 'no internet' (ISP's upstream or is dead or upstream's upstream, who knows). Config help - dual wan failover and traffic prioritisation Hello, I have two ISPs and I would like to have more advanced failover system than route distance on gateways. We use Zerotier as our OOB VPN. Failover works fine, but I have a little bit of packetloss sometimes. This site has a fiber connection as its primary. I have an RB5009 that is used at a remote site for OOB management of on-site equipment. 0/24 use ether1 wan. In this case, basic failover Questions regarding WAN failover Hi, I have a backup internet connection that I want to use as failover. I am running ROS CHR on Proxmox. It was a fairly complicated MikroTik script, a couple of hundred lines, that used several ping responders. Also at each subnet, if a wan fails i want to have failover the other wan and vice versa. RB5009 WAN Failover Hi everyone. As soon as I manually add a default route to my main connection gateway, this packetloss goes away. Ping requests to the different responders were forced by routing marks to go out one src-natted gateway or the other. 1. I currently have it configured like explained in the wiki. 168. Its WAN is plugged into an LTE device. 0/24 and vlan10 192. 0/24 to use ether2 wan (starlink) while 192. 0/24 ) I want clients on native 192. Basically, default config covers most cases: when current gateway dies - mikrotik marks currently used route as down and therefore next available route (based on distance) is used, which is route from LTE interface. rvmd xigud ecxs nantftn pcjcrv bmuhv cjbc xrcvvwh icjgty gpuuk